-2 8-
CHASSIS
- 208-
CHECKING THE FRONT BRAKE DISC
1. Check:
• rake isc
Galling amage
Replace.
. Measure
• rake isc eflection
Out of specification
Check the wheel runout.
If wheel runout is within the limits replace the
rake isc.
Brake disc maximum deflection
0.10 mm (0.004 in)
• rake isc thickness
• wheel hu
• wheel tyre
Out of specification
Replace.
Brake disc minimum thickness
3.0 mm (0.12 in)
NOTE
Apply the locking agent to the 30Nm bolt with
screw down.
CHASSIS
- 209-
REPLACING THE FRONT BRAKE PADS
NOTE
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Check:
• rake pa
Damage wear
Replace
.Measure
• rake pa thickness
ⓐ
Out of specification
Replace the rake
pa s as a set.
Brake pad wear limit
1.5 mm (0.06 in)
3. Install
• rake pa s
• rake pa spring
NOTE
Always install new brake pads and brake pad
spring as a set.
a. Connect a suita le hose tightly to the rake
caliper lee no le . Put the other en of this
hose into an open container.
. oosen the rake caliper lee screw an
using a finger push the caliper piston into the
rake caliper.
c. Tighten the rake caliper lee screw.
Brake caliper bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb
)
. Install the retaining olts an rake caliper.
Brake pad holding bolt
18Nm (1.8 m · kg, 13 ft · lb)
