- 4-
MAINTENCE AND ADJUSTMENT OF THE UTV
- 94 -
WARNING
Use a cleaning solvent which is designed to
clean parts only. Never use gasoline or low
flash point solvents as they may cause a
fire or explosion.
b. squeeze the excess solvent out of the element
and let it dry.
NOTE
Do not twist or wring out the element. This could
damage the foam material.
c. Squeeze out the excess oil.
NOTE
The element should be wet but not dripping.
4. Install:
air filter element
air filter case cover
NOTE
To prevent air leaks make sure that the sealing
surface of the element matches the sealing
surface of the case.
console
passenger seat
driver seat
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Remove front faceplate
3. Check:
start the engine, warm it up for several minutes,
and then turn it off.
coolant level
NOTE
Before checking the coolant level, wait a few
minutes until the coolant has settled.
MAINTENCE AND ADJUSTMENT OF THE UTV
- 95 -
coolant level
The coolant level should be between the
minimum level mark
a
and maximum level
mark
b
.Below the minimum level mark
Add the recommended coolant to the proper level.
CHANGING THE COOLANT
1.Remove:
Front faceplate
coolant reservoir cap
①
Disconnect coolant reservoir hose
②
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is used
instead of coolant, check and if necessary,
correct the antifreeze concentration of the
coolant
Use only distilled water. However, soft water
may be used if distilled water is not available.
2. Drain:
coolant
(from the coolant reservoir)
3. Connect:
coolant reservoir hose
4. Remove:
coolant drain bolt (water pump)
(along with the
①
copper washer)
