- 22-
MAINTENCE AND ADJUSTMENT OF THE UTV
- 122 -
Charging method using a constant voltage charger
NOTE
Leave the battery unused for more than 30
minutes before measuring its open-circuit
voltage.
.
Measure the open-circuit voltage
prior to charging.
Connect a charger and ammeter to
the battery and start charging.
I
s the amperage higher than the
standard charging amperage
written on the battery?
Charge the battery until the
charging voltage reaches 15 V.
This type of battery charger cannot
charge an MF battery. A variable
voltage charger is recommended.
Leave the battery unused for more than 30
minutes before measuring its open-circuit
voltage.
12.8 V
Charging is complete.
12.0 ~ 12.7 V
Recharging is required.
Under 12.0 V
Replace the battery
YES
NO
NOTE
Set the charging time to a
maximum of 20 hours.
Charge the battery until the
charging voltage reaches 14.2 V.
MAINTENCE AND ADJUSTMENT OF THE UTV
- 123 -
NOTE
Constant amperage chargers are not suitable
for charging MF batteries.
3. Install:
• attery
• Connect
attery lea s
NOTE
First, connect the positive battery lead
①
, and
then the negative battery lead
②
.
• Check
attery terminals Dirt
Clean with a wire rush.
oose connection
Connect properly.
• u ricate
attery terminals
• Install
attery case co er
• Close the hoo .
CHECKING THE FUSES
NOTE
Always turn off the main switch when
checking or replacing a fuse. Otherwise, a
short circuit may occur.
. Remo e
• lift the hoo up.
• attery case co er
. Check
• fuses
a. Connect the pocket tester to the fuse an check it
for continuity
NOTE
Set the tester to the “ × 1” position.
• lown fuse
