- 2-
MAINTENANCE AND ADJUSTMENT OF THE UTV
- 92 -
disassembly sequence reverse operation.
.
6. Install
engine oil drain bolt
Final gear oil drain bolt
7. conditions
Change for new oil filter before impouring oil to
crankcase, and make sure it is in good working
condition before assembling.
make sure that the oil reach regular level when the
vehicle is placed on flat ground.
Oil level of gearbox
Periodic oil change
The oil capacity after the engine is
disassembled and reassembled.
2L
The oil should be put into the engine for after
all the oil is drawn out
2L
8. Install:
engine oil filler plug
9. Worm up the engine for a few minutes, and then
stop the engine.
10. Check:
engine (for engine oil leaks)
refer to Chapter 4 check the level of engine oil
11. Check:
engine oil pressure
12. Install:
console
passenger seat
driver seat
Refer to “SEATS” in chapter 5.
MAINTENCE AND ADJUSTMENT OF THE UTV
- 93 -
CHASSIS
CLEANING THE AIR FILTER
NOTE
There is a check hose
at the bottom of the
air filter case. If dust and/or water collect in
this hose, clean the air filter element and air
filter case.
1. Remove:
air filter case cover
air filter element assembly
air filter element
NOTE
Never operate the engine with the air filter
element removed. This will allow unfiltered air to
enter, causing rapid wear and possible engine
damage. Additionally, operation without the
filter element will affect
carburetor tuning with
subsequent poor performance and possible
engine overheating.
2. Check:
air filter element
Damaged
Replace.
3. Clean:
air filter element
a. Wash the element gently, but thoroughly in
solvent.
