- 8-
MAINTENCE AND ADJUSTMENT OF THE UTV
- 98 -
.
NOTE
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check, and if
necessary, correct the antifreeze concentration
of the coolant. Use only distilled water.
However, soft water may be used if distilled
water is not available.
14. Install:
air bleed bolt
9 Nm (0.9 m · kg, 6.5 ft · lb)
radiator cap
Fill coolant reservoir
Install coolant reservoir cap:
Start the engine, warm it up for several minutes,
and then turn it off.
Check:
coolant level
Refer to “THE COOLANT” in chapter 4.
NOTE
Before checking the coolant level, wait a few
minutes until the coolant has settled.
Close the hood.
Install driver seat
Refer to “SEATS,” in chapter 5.
CHECKING THE COOLANT TEMPERATURE
WARNING LIGHT
Coolant temperature indicator light
①
MAINTENCE AND ADJUSTMENT OF THE UTV
- 99 -
.
CHECKING THE V-BELT
1. Remove:
driver seat
drive belt cover
Check:
a. V-belt
①
Cracks/wear/scaling/chipping
Replace.
Oil/ grease
Check primary sheave and
secondary sheave
b. V-belt width
②
Out of specification
Replace.
.
Coolant temperature warning light checking method
Turn the main switch “ON”.
Coolant temperature warning light
does not come on.
Coolant temperature warning light
come on.
Turn the main switch to “START”
with the transmission in neutral
position.
Coolant temperature warning light
comes on momentarily .
Coolant temperature warning
light does not come on.
Coolant temperature and electrical
circuit are OK .Go ahead with riding.
Check the electrical circuit
