7:6
UGG050-0517
S Series
Advanced
(E)
(F)
(A)
(B)
(D)
(C)
Level 0
T I M E D
A B S
S T O P
←
0 0 0 0 0
H O U R S
→
A B S
S T O P
←
0 0 0 0 0
H O U R S
→
SER
VICE
7. SERVICE
Adjust the ABS-system
Adjust the timing relay,
Advanced
1. Read page 7:5 “General rules, Adjust the ABS-sys-
tem”.
2. Read page 2:30 “Timed ABS, Rotor”.
3. Read page 2:32 “Timed ABS, Masher-system”.
4. Check that “Timed ABS” is selected. Refer to figure (E).
>Page 7:5 “Select ABS mode, Advanced”.
5. Adjust the timing relay:
>Page 7:6 point 2–4 “Adjust the ABS settings”.
Adjust the ABS settings,
Advanced
1. Read page 7:5 “General rules, Adjust the ABS-sys-
tem”.
2. Adjust the ABS settings:
a) Stop the granulator. >Page 5:1 point 1–2.
b) Start “Level 1”. >Page 7:5.
c) Press the edit-button “Right” until the desired
“Level 1” message appears.
>Page 2:21–2:22 “Level 1” messages.
d) Press the edit-button “MOD”.
e) A cursor appears.
f) Change the values / the parameters by pressing the
edit-buttons “Up” or “Down”.
g) Accept entered values / parameters by pressing the
OK-button.
3. Repeat point 2 above until all ABS settings that are to
be changed are changed.
4. When all setting are changed: Press the edit-button
“Right” until “Level 1” is terminated and the “Level
0” message “Timed ABS” or “ABS” appears.
Refer to figure (E) or (F).
(A) = Edit-button “Up”
(B) = Edit-button “Right”
(C) = Edit-button “MOD”
(D) = OK-button
(E) = Level 0, “Timed ABS” is selected
(F) = Level 0, “Automatic ABS” is selected