2:10
UGG050-0517
S Series
(D)
(B)
(C)
(E)
(A)
(B)
(D)
DESCRIPTION
Gear motor
The granulator is driven by an electrical gear motor.
Optional motor power: 0.75 kW, 1.5 kW or 2.2 kW.
Motor power and motor frequency are specified on the
motor’s machine plate.
The gear motor is filled with oil. In normal operation, the
oil does not need to be refilled / changed. If refilling /
changing of oil should be necessary, use the type of oil
specified on the gear motor’s type plate.
The oil level in the gear motor must be checked regularly.
>Page 7:9 “Check the transmission”.
>Page 9:31-9:33 “Transmission”.
Coupling
The coupling inside the transmission is provided with a
plastic damper. The plastic damper must be regularly
checked and replaced as necessary.
>Page 7:9 ”Check the transmission”.
>Page 9:25 “Rotor”.
Bearings
All bearings in the granulator are lubricated for life and
must not be re-greased. >Page 9:25 “Rotor”.
Note! If material get into the bearing housing, the
material might melt and cause serious or irreparable
damage to the bearings. There is one sealing in each short
block of the cutter housing. The left sealing is a left-hand
threaded and the right sealing is right-hand threaded. The
reversed thread deflects fed material and prevent it from
penetrating the bearings. The sealings must be regularly
checked and replaced as necessary. >Page 2:9 “Sealings”.
Transmission
2. DESCRIPTION
(A) = Gear motor
(B) = Transmission cover
(C) = Tightening screws
(D) = Plastic damper, Transmission
(E) = Oil level device (S918-Twin)