7:14
UGG050-0517
S Series
(G)
(C)
(F)
(E)
(D)
(H)
(A)
(B)
SER
VICE
7. SERVICE
Install the rotating knife segments
and the rotating feed hook(s)
1. Remove the rotating knife segments and the rotating
feed hook(s). >Page 7:13.
2. Check the knife sharpness. Grind or replace the
rotating knife segments / the rotating feed hook(s) as
necessary. >Page 7:16 “Grind the rotating knife
segments”.
3. Install the rotating knife segments and the rotating
feed hook(s). Push in the rotor shaft. Refer to figure
(G). Push in a little bit at the time and at the same
time install the rotating knife segments / the rotating
feed hook(s).
Note! Hold the rotating knife / the feed hook while
pulling out / pushing in the rotor shaft, so that the
rotating knife / the rotating feed hook does not fall
uncontrolled.
4. Close / fold down the cutter housing’s upper frame.
>Page 6:4 “Close the cutter housing”.
5. Re-install the coupling.
6. Install the rotor shaft’s washer and tightening screw.
Refer to figure (C). Tighten the tightening screw.
Tightening torque 544 Nm. Keep the rotor still while
unscrewing / tightening the rotor shaft, by locking one
of the rotating feed hooks with a piece of wood.
Refer to figure on the right.
7. Close the transmission. >Page 6:5.
8. Install the rotor shaft’s cover. Refer to figure (A).
Tighten the cover’s tightening screws. Tightening
torque 69 Nm.
7. SERVICE
Knives
(A) = Cover, Rotorshaft
(B) = Tightening screw, Cover
(C) = Tightening screw, Washer, Rotorshaft
(D) = Cutter housing’s upper frame
(E) = Rotating knife segment
(F) = Rotating feed hook
(G) = Rotorshaft
(H) = Coupling