1:4
SAFETY
UGG050-0517
S Series
1. SAFETY RULES
Safety rules, During service
• The instruction manual must be carefully observed to avoid personal injury and machinery damage.
• National environmental and employee safety regulations must be followed.
• First aid and eye shower must be within reach.
• Daily service and daily checks may be done by the operator. All other service and inspections must be done by author-
ized, trained personnel.
• Always work alone when service actions is performed.
• Use protective goggles and gloves.
• The machine must be stopped.
• The machine must be disconnected from the mains before electrical repairs or electrical installing is began.
• Granulator with electrical cabinet “Basic”: The machine’s emergency stop must be locked with a padlock. Never
insert any part of your body into any opening, unless the emergency stop is locked with a padlock.
• Granulator with electrical cabinet “Extended” or “Advanced”: The machine’s main switch must be locked in position
“0”. Never insert any part of your body into any opening, unless the main switch is locked in position “0”.
• Be very careful – When opening and closing the machine. Risk of cutting or pinch injuries! When the cutter housing’s
upper frame is opened, it must be manually locked by a piece of wood.
• Be very careful – When the machine is opened the knives are accessible. The knives are sharp, and they may cause
personal injuries even when they are not rotating. Risk of cutting or pinch injuries!
• Be very careful – When pulling the rotor or the rotor pulley manually. Risk of cutting or pinch injuries!
• Be very careful – When cleaning. Granulate and plastic residue can make the floor slippery.
• Be very careful – When working on high level. Only use specially installed and fastened steps, stairs and platforms. It
is not permissible to remove any outer safety equipment such as protective screens, bars, nets etc.
• After service / check is done all covers must be reinstalled. All hatches to electrical cabinet, transmission and pneu-
matics (if supplied) must be closed and locked. The key must be kept by the personnel responsible for the machine’s
service and safety.
