5
UGG050-0517
S Series
INTRODUCTION
CONTENT
3. TRANSPORT / LIFT
Transport / Lift ...........................................................3:1
General rules, Transport / Lift .......................... 3:1
Transport ............................................................ 3:1
Lift the granulator .............................................. 3:1
4. INSTALLING
Actions before first start ............................................4:1
General rules, Installing ..................................... 4:1
Reception inspection .......................................... 4:1
Put the machine in its working place ................ 4:1
Remove the rust preventer ................................. 4:1
Check the knife clearance .................................. 4:2
Technical specifications .................................... 4:2
Electrical connection ..................................................4:3
General rules, Electrical connection .................. 4:3
Emergency stop ................................................. 4:3
Connect the granulator to the mains .................. 4:3
Checks immediately after first start .........................4:4
Checks 40 hours after first start ...............................4:5
Installing complete .....................................................4:5
5. START / STOP
Start the granulator ...................................................5:1
Stop the granulator ....................................................5:1
Manual reversal of the rotors and/or the Masher-
system ..........................................................................5:2
6. OPEN / CLOSE
Open the granulator...................................................6:1
General rules, Open the granulator .................... 6:1
Open the transmission ........................................ 6:1
Open the hopper ................................................. 6:2
Open the cutter housing ..................................... 6:2
Open the granule bin .......................................... 6:3
Close the granulator...................................................6:3
General rules, Close the granulator .................. 6:3
Close the granule bin ......................................... 6:3
Close the cutter housing ..................................... 6:4
Close the hopper ................................................ 6:4
Close the transmission ....................................... 6:5
7. SERVICE
General rules, Service ................................................7:1
Check the emergency stop(s) .....................................7:1
Check the flap(s) ........................................................7:1
Service schedule ................................................ 7:1
Check the safety equipment ......................................7:2
Check the electrical components ..............................7:3
Store the granulator ...................................................7:3
Adjust the IMD-System .............................................7:4
General rules, Adjust the IMD-System ............. 7:4
Basic, Extended, Advanced .............................. 7:4
Adjust the ABS-System..............................................7:5
Select ABS mode, Advanced ............................. 7:5
Start “Level 1” ................................................... 7:5
Adjust the timing relay, Advanced .................... 7:6
Adjust the ABS settings, Advanced .................. 7:6
Adjust the level switch ...............................................7:7
Adjust the pause-pulse relay, Airveyor ....................7:8
Check the transmission..............................................7:9
Clean the granulator ................................................7:10
Thorough inspection ................................................ 7:11
Reset “Maintenance request” ......................... 7:11
Knives ........................................................................7:12
General rules, Knives ....................................... 7:12
Remove the rotating knife segments and the rotating
feed hook(s) .................................................... 7:13
Install the rotating knife segments and the rotating
feed hook(s) .................................................... 7:14
Remove the fixed knives and the scrapers ...... 7:15
Install the fixed knives and the scrapers ......... 7:15
General rules, Grind the knives ...................... 7:16
Grind the rotating knife segments ................... 7:16
Grind the fixed knives .................................... 7:17
Grind the scrapers ........................................... 7:17
Fault tracing .............................................................7:18