7:12
UGG050-0517
S Series
SER
VICE
7. SERVICE
Knives
General rules, Knives
1. Read page 7:1 “General rules, Service”.
2. Read page 2:9 “Cutter housing”.
3. Read page 2:10 “Fixed knives” and “Scrapers”.
4. Read page 2:11 “Rotor”, “Rotating knife segment
segments” and ”Rotating feed hook(s)”.
5. All screws and nuts that are sealed with red paint, are
permanently set and glued. These screws and nuts
must under no circumstances be unscrewed, tightened
or changed.
6. Knife sharpness and knife clearance must be checked
regularly. The granulator must never be used with
blunt knives. Blunt knives cause abnormal wear and
damages the granulator.
7. Every second time tightening screws are unscrewed
they must be replaced with new ones.
8. Every time washers are unscrewed they must be
replaced with new ones.
9. When replacing knives, scrapers, feed hook(s),
tightening screws and washers, only use original spare
parts supplied by Conair.
10. The rotor can rotate by itself. Always lock the rotor’s
position with a piece of wood while changing the
knives.
11. When the cutter housing’s upper frame is opened, it
must be manually locked by a piece of wood.
12. Respect specified tightening torques. Use a torque
wrench.
13. Respect specified measures.
If any of the above listed rules are left unattended,
Conair’s responsibility under the Machinery Directive
ceases to apply.