Upgrading the ProLiant Clusters HA/F100 and HA/F200
4-19
Compaq Confidential – Need to Know Required
Writer: Bryan Hicks Project: Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide Comments:
Part Number: 380362-003 File Name: e-ch4 Upgrading the ProLiant Clusters HAF100 and HAF200.doc Last Saved On: 8/24/00 12:02 PM
14.
Verify the cluster by running the Compaq Cluster Verification Utility.
Instructions for installing and running this utility can be found in
Chapter 3 of this guide.
15.
Verify that Secure Path is running properly and that the redundant paths
are operational. See the Secure Path documentation for details on
running this program.
16.
Install your applications, managing and monitoring software as needed.
These may include Compaq Insight Manager, Compaq Insight Manager
XE, Compaq Intelligent Cluster Administrator, and other applications
needed on this cluster.
Migration Process V: HA/F100 Windows
NTS/E to HA/F200 Windows NTS/E
This procedure cannot be performed as a rolling upgrade. The cluster must be
shut down causing the cluster to be unavailable to clients during the migration.
IMPORTANT:
Back up all data before beginning the migration process.
The basic steps to this upgrade include:
1.
Upgrading the operating system drivers
2.
Installing Compaq Redundancy Manager
3.
Adding the redundant loop hardware
4.
Updating the RA4000 Controller firmware
5.
Installing the latest Microsoft Service Packs
To migrate from HA/F100 Windows NTS/E to HA/F200 Windows NTS/E,
use the following steps:
1.
Install the latest drivers and server support software by running the
Compaq Server Support Software (SSD) for Windows NT on both
nodes:
Inserting the SmartStart CD and selecting Start and then Run. In the
dialog box that displays, type
X:\cpqsupsw\ntssd\setup.exe
where X is the
drive letter associated with your CD-ROM drive.
You can also acquire and run the latest Compaq Support Paq from the
Compaq website (
http://www.compaq.com/support
).
Summary of Contents for ProLiant Clusters HA/F100
Page 8: ......