4-6
Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide
Compaq Confidential – Need to Know Required
Writer: Bryan Hicks Project: Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide Comments:
Part Number: 380362-003 File Name: e-ch4 Upgrading the ProLiant Clusters HAF100 and HAF200.doc Last Saved On: 8/24/00 12:02 PM
2.
Upgrade Node 1 to Windows 2000 Advanced Server:
a.
Run the Compaq Windows 2000 Primer Utility to remove any
conflicting device drivers or applications that may cause problems
during the install or operation of Windows 2000 Advanced Server.
The Primer Utility can be downloaded from the Compaq website
(
http://www.compaq.com/partners/microsoft/
). After the Primer has
run, you will be asked to reboot the node to finish the cleanup
process.
b.
Once the node has been rebooted, insert the Windows 2000
Advanced Server CD into the CD-ROM drive. If the Autorun feature
for CDs has been turned off, select Start and then Run. At the
prompt type
X:\Setup.exe
, where X is the drive letter of your CD-ROM
drive. When asked if you want to upgrade Windows, select Yes.
c.
Follow the on-screen instructions until you are required to log on to
the node.
d.
Log on to the node as the administrator.
NOTE:
After the upgrade is complete, the Cluster Service will fail to start. This is
because the DNS client for Node 1 has not been set up. The problem that occurs is
an authentication error with the user account used to start the Cluster Service. The
error message is expected and will be resolved after the DNS client is set up.
3.
Set up the DNS client on Node 1:
a.
Right-click My Network Places and click Properties.
b.
Right-click on the network connection that the clients will use to
connect to the domain controller and click Properties.
c.
The Properties screen displays the current options available for the
selected network card. Highlight Internet Protocol (TCP/IP), and
click Properties.
d.
Enter the Preferred DNS Server IP address.
e.
Click the Advanced button and then select the DNS tab. Enter the
DNS suffix.
f.
After the client setup is complete, select Start, then select Shutdown.
From the shutdown screen, select Log Off Administrator, then log
back into the system. This ensures that the domain controller has
properly authenticated the machine and user ID.
Summary of Contents for ProLiant Clusters HA/F100
Page 8: ......
