Figure 1–3 Loop Between Nodes on Either Side of the DEC MicroServer
LKG−2947−89R
Load Host
DECnet−DOS
DECnet
•
If the fault still occurs, it is likely that the Ethernet connection is at
fault. Contact Digital service representative to repair the unit.
4.
Make sure the DEC MicroServer has completed its self-test procedure by
checking the display on the DEC MicroServer. Refer to Appendix C for
DEC MicroServer display values.
5.
Check that the load host is running properly. Try to load the Gateway-ST
again.
6.
Check that each load host has a physical connection to the same Ethernet
as the DEC MicroServer.
7.
Check that each load host has a database entry for the DEC MicroServer.
Identify the load hosts, and perform the following actions:
•
Enter the following command (for Phase IV):
NCP TELL
load-host-name SHOW NODE gateway-node-name _CHARACTERISTICS
Solving DECnet SNA Gateway for Synchronous Transport Problems 1–17
