Session Problem 3
The Gateway-ST does not recognize the LU names you specify.
Solution:
1.
Check that the PU name is defined. See Session Problem 2 for more
information about specifying a PU name.
2.
The LUs you want to use might not be defined on your Gateway-ST. Use
the SNANCP command SHOW KNOWN LUS to find out whether the LUs
you want to use are defined and are active. If the LUs are not defined, use
the following SNANCP command to define them on the Gateway-ST:
SNANCP> SET PU
pu-id LU LIST lu-list
For information on defining LUs with SNANCP commands, refer to the
DECnet SNA Gateway-CT and ST Management book.
To ensure that the Gateway-ST is initialized with these LUs next time it is
loaded, edit the SNA configuration file on the load host:
SYS$COMMON:[SNA$CSV]SNAGATEWAY_gateway-node-name_SNA.COM
1–44 Solving DECnet SNA Gateway for Synchronous Transport Problems
