D.3 Detaching the Console
After you finish using the remote console, press
Ctrl/D
to detach the console.
The NCP prompt appears on your terminal:
NCP>
D.4 Halting the Software
The remote console HALT command stops the communications software. HALT
can also be used to stop a software load or a system dump. The format of the
command is:
>>>HALT
Use this command before you issue any of the following remote console
commands:
•
BOOT
•
DUMP
•
TEST
D.5 Testing the DEC MicroServer
The remote console TEST command has two formats that you can use to test
the DEC MicroServer:
•
The first format lets you test the synchronous communications ports, their
modem control lines, and the adapter cables.
•
The second format allows you to run continuous tests of the
DEC MicroServer.
The first format of the remote console TEST command is:
TEST) type channel/qualifier
where:
type
Determines the type of test you want to perform. Specify one of the
following test types:
DATA_LOOPBACK
MODEM_SIGNAL
CABLE_TYPE
DEC MicroServer Facilities for Problem Solving D–3
