Club Car DS Villager 4, Maintenance And Service Manual, Page: 134 / 510

7
Front Suspension STEERING AND FRONT SUSPENSION
3. Loosen the four bolts (1). Do not remove the bolts (Figure 7-9) .
2
3
1
673B
Figure 7-9 Adjust Camber
4. Loosen the nut (2) on the adjustment eccentric (3) in the center of the spring. Do not remove the nut.
5. Use a 7 mm deep well socket to rotate the adjustment eccentric and adjust the camber.
6. Tighten the four bolts in a crisscross pattern to 37 lb·ft (50 N·m).
7. Move the vehicle forward one full tire revolution.
8. Check the camber.
9. When the camber adjustment is complete, tighten the nut on the adjustment eccentric to 10 lb·ft (13.5 N·m).
Toe-in Adjustment
1. Park the vehicle on a solid level surface.
2. Roll the vehicle forward, then stop the vehicle.
3. Make sure the front wheels are pointed straight ahead.
CAUTION
• Do not turn the steering wheel again during this procedure.
4. On each front tire, mark (as closely as possible) the center of the tread face that is toward the rear of the vehicle.
The marks should be even with the bottom surfaces of the vehicle frame.
5. Measure the distance between the marks on the rear-facing surfaces of the tires.
6. Roll the vehicle forward one and a half wheel revolutions until the marks appear on the forward facing surfaces
of the tires at about the same height from the floor.
Page 7-10 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual