6
Brake Cable Equalizer Adjustment
WHEEL BRAKE ASSEMBLIES
BRAKE CABLE EQUALIZER ADJUSTMENT
1.
Make sure that the brake pedal is in the fully up position.
2.
Adjust the turnbuckle (1) until the distance between the top of the brake cable equalizer (2) and the upper flange
surface (3) is 2 inches (±1/16) (51 mm (±1.6)
.
4
1
2
3
649B
Figure 6-19
Equalizer Adjustment
3.
Make sure that the threaded rods are visible in the holes (4) of the turnbuckle.
4.
Snug the front and rear jam nuts to their respective surfaces, then back the nuts off 1/4 to 3/8 inch (6.4 to 9.5 mm)
and apply Loctite
®
242 on the threads for both front and rear jam nuts.
WARNING
• Reduced braking force could result if the jam nuts are not tightened in the proper sequence.
5.
Tighten the rear jam nut first to 208 lb·in (23.5 N·m), then tighten the front jam nut to 208 lb·in (23.5 N·m). For
optimal performance, drive the vehicle and apply the brakes approximately 20 times to burnish the shoes,
center the clusters, and adjust the brake mechanism.
6.
Measure the distance between the top of the brake cable equalizer and the upper flange surface.
7.
If the measurement is 2 inches (±1/16) (51 mm (±1.6), the adjustment is complete.
8.
If the measurement is not 2 inches (±1/16) (51 mm (±1.6):
8.1.
Repeat the adjustment procedure.
9.
Install the access panel.
10.
Install the floor mat.
Page 6-12
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Summary of Contents for DS Villager 4
