![background image](http://html1.mh-extra.com/html/club-car/1997-ds/1997-ds_maintenance-service-supplement_2626738064.webp)
Page 56
10
G
INTERMEDIATE GEAR ASSEMBLY
1. If the gear (58) was removed from the shaft, install the key (57) into the slot and then position the gear
on the shaft with keyway properly aligned with key (Figure 10-43, Page 53). Press the gear into place
on the key.
2. Press the bearing (59) onto the end of the shaft next to the large gear that was installed in step one
(Figure 10-43). See CAUTION below.
3. Press a new bearing (38) onto the other end of the shaft (Figure 10-43, Page 53).
• APPLY PRESSURE AGAINST THE INNER RACE OF THE BEARING ONLY. APPLYING PRES-
SURE ANYWHERE ELSE WILL DAMAGE THE BEARING.
FIGURE 10-51
FIGURE 10-52
FIGURE 10-53
FIGURE 10-54
• APPLY PRESSURE AGAINST THE INNER RACE OF THE BEARING ONLY. APPLYING PRES-
SURE ANYWHERE ELSE WILL DAMAGE THE BEARING.
CAUTION
USE A 7/8" O.D. OR
SMALLER ARBOR AND
A BEARING PULLER
WEDGE ATTACHMENT
(CLUB CAR #1012812)
TO PRESS BEARING
FROM SHAFT
ARBOR
PRESS
RAM
WEDGE
ATTACHMENT
ARBOR
PRESS RAM
PRESS IDLER SHAFT
FROM BEARING USING
A 3/4" O.D. OR LESS
ARBOR AND A
WEDGE ATTACHMENT
(CLUB CAR # 1012812)
ARBOR
PRESS RAM
PRESS IDLER SHAFT
FROM BEARING USING
A 3/4" OR LESS O.D.
ARBOR, AND A
WEDGE ATTACHMENT
(CLUB CAR # 1012812)
WEDGE
ATTACHMENT
A
B
CAUTION
Summary of Contents for 1997 DS
