Club Car 1997 DS, Maintenance Service Supplement

Page: 129 / 164

Page 121
G
12
ACCELERATOR STARTER LIMIT SWITCH
Removing the Accelerator Starter Limit Switch (Figure 12-50)
1. Remove seat from body.
2. Disconnect battery wires as shown (Figure 12-1, Page 82).
3. Remove electrical component box cover (1).
4. Disconnect the green wire and the orange wire from the accelerator starter limit switch (11).
5. Remove the two nuts (9) and washers (10) that secure the accelerator limit switch in place.
6. Remove the accelerator starter limit switch.
Installing the Accelerator Starter Limit Switch (Figure 12-50)
1. Install the accelerator starter limit switch (11) onto the two screws (16) and secure the switch in place
using the two washers (10) and the two nuts (9). Torque to 5 in.lbs. (0.6 N-m).
2. Connect green wire to common (COM) terminal and the orange wire to the normally closed (NC) termi-
nal of the accelerator starter limit switch (Figure 12-2, Page 83).
3. Depress the accelerator pedal to make sure that the switch is being actuated when the pedal is
released.
4. Connect battery cables, positive cable first.
5. Install the seat on the rear body.
KILL LIMIT SWITCH
Removing the Kill Limit Switch (Figure 12-50)
1. Remove seat from body.
2. Disconnect battery wires as shown (Figure 12-1, Page 82).
3. Remove electrical component box cover (1).
• DO NOT OVER-TIGHTEN THE RETAINING NUTS. IF THE NUTS ARE OVER-TORQUED, LIMIT
SWITCHES COULD BE DAMAGED.
FIGURE 12-50
WARNING
1
9
10
11
12
13
14
15
16
21
TYPICAL 2
PLACES
8
TYPICAL 2
PLACES
BLACK WIRE
ASSEMBLY
TYPICAL 2
PLACES
20