Club Car 1997 DS, Maintenance Service Supplement

Page: 29 / 164

Page 21
G
E
1-9
• PowerDrive System 48 and PowerDrive Plus Vehicles, Serial Numbers Prior to 9711-564736 -
Adjust the Actuator Lever (There is no accelerator rod on PowerDrive System 48 or PowerDrive
Plus vehicles prior to serial number 9711-564736):
4.1. Connect the Calibration Test Module (Club Car Part No. 1018871-01) (Figure 6-12, Page 22) to
the vehicle.
4.1.1. Disconnect the 3-wire connector to the potentiometer from the wire harness as shown (Fig-
ure 6-13, Page 22).
4.1.2. Connect the 3-wire plug of the Calibration Test Module to the 3-wire connector from the
potentiometer (Figures 6-12 and 6-13, Page 22).
4.1.3. Disconnect the green/white wire from the potentiometer housing assembly (Figure 6-13,
Page 22) at the Forward and Reverse Limit Switch No. 1 on standard PowerDrive System
48 vehicles, or at the main wire harness (under the charger receptacle) on PowerDrive
Plus vehicles with motor braking.
4.1.4. Connect the green/white wire from the potentiometer housing to the green lead from the
Calibration Test Module (Figure 6-13).
4.1.5. If it is not already disconnected, disconnect the 6 gauge red wire from the positive (+) post
of battery No. 6. Connect the Calibration Test Module’s alligator clip to the end of the 6
gauge red wire.
FIGURE 6-11
8
3
1
6
22
25
26
4
24
23
16
5
10
8
5
12
13
21
5
19
7
20
TYPICAL
4 PLACES
TYPICAL
4 PLACES
TYPICAL
4 PLACES
2
18
14
9
23
11
7
21
ALL 1997 GASOLINE AND
V-GLIDE 36 VOLT VEHICLES,
ALSO POWERDRIVE SYSTEM 48
AND POWERDRIVE PLUS VEHICLES
SERIAL NUMBERS 9711-564736
AND LATER.