Cisco ?mi telepresence, User Manual

Page: 125 / 128

Regulatory standards compliance 125
Statement 2019—FCC Declaration of Conformity Information (for USA only)
Product: Cisco ūmi telepresence
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Equipment must be installed and operated using the relevant manuals and only installed with the correct cables and
connectors. Cisco Systems Inc. is not responsible for any radio or television interference caused by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could void the users authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Responsible party:
Cisco Systems Inc.
170 West Tasman Drive
San Jose, CA 95134
USA
+408 526-7208
Regulatory standards compliance
This section includes all regulatory, safety, EMC (Class A or Class B), telecom, and NEBS standards.
The Cisco ūmi telepresence is in compliance with national and international standards as described in Table 1.
Regulatory standards compliance: Safety & EMC
Specification Description
Regulatory Compliance
(Mandatory) Products with the CE Marking indicate compliance with the 1999/5/EC directive, which
includes the safety and EMC standards listed.
Safety (Mandatory) UL 60950-1
CAN/CSA-C22.2 No. 60950-1
EN 60950-1
IEC 60950-1
AS/NZS 60950-1