4-40
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
redundancy reload
redundancy reload
To reset the standby PRE1 module or to reset both the active and standby PRE1 modules, use the
redundancy reload
command in privileged EXEC mode.
redundancy reload
{
peer
|
shelf
}
Syntax Description
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
redundancy reload peer
command reloads the Cisco IOS software on the standby PRE1 module,
which does not have an impact on router operations, assuming a switchover is not required while the
standby module is resetting. The
redundancy reload shelf
command reloads the Cisco IOS software on
both the active and standby PRE1 modules, which will interrupt services on the router until all PRE1
modules and line cards initialize and come back online.
Examples
The following example shows a switchover being manually initiated, overriding any checks that might
prevent or delay the switchover:
Router#
redundancy reload peer
Reload peer? [confirm]
y
Preparing to reload peer
Note
Pressing
enter
or
y
confirms the action and begins the reload. Pressing any other key aborts the reload
and returns control to the current active PRE1 module.
The following example shows the system’s response when a standby PRE1 module is not installed in the
router:
Router#
redundancy reload peer
System is running in SIMPLEX mode, reload anyway? [confirm]
n
Peer reload not performed.
Router#
peer
Reloads only the standby PRE1 module.
shelf
Reloads both the active and standby PRE1 module.
Release
Modification
12.2(4)XF1
This command was introduced for the Cisco uBR10012 router.