Canon EOS C300 Mark III, Manual

Page: 200 / 254

Menu Options
200
[Camera REC Button],
[Camera Grip REC Button],
[Grip SG-1 REC Button] [Disable],
[Enable]
Independently enables or disables the use of the REC buttons on the camera, camera grip, or optional
SG-1 Shoulder Style Grip. These settings are available only in CAMERA mode.
[Tally Lamp (Front)],
[Tally Lamp (Rear)],
[CFexpress Access LED],
[SD Card Access LED],
[
(Ethernet) LED]
[On]
, [Off]
These settings determine whether the following LEDs and indicators will illuminate.
[Tally Lamp (Front)], [Tally Lamp (Rear)]: The tally lamps on the camera.
[CFexpress Access LED], [SD Card Access LED]: The respective card access indicator when the camera is
accessing the card.
[ (Ethernet) LED]: The (Ethernet) indicator on an optional EU-V1 or EU-V2 Expansion Unit when
the camera is accessing a wired network.
[Fan Mode] [Automatic],
[Always On]
(
A
61)
[Fan Speed (STBY)] [Maximum], [High], [Middle],
[Low]
[Fan Speed (REC)],
[Fan Speed (Always)] [High], [Middle],
[Low]
[Fan Speed] [High], [Middle],
[Low]
(
A
61)
[Touch Screen Response]
[Normal]
, [Low] (
A
31)
[Review Recording]
[Entire Clip]
, [Last 4 sec] (
A
114)
[GPS Auto Time]
3
[On],
[Off]
When this setting is set to [On], the camera automatically adjust its date and time settings according to
the information received from the GPS signal. The date and time will be updated automatically the first
time a correct GPS signal is acquired after turning on the camera. This setting is available only in CAMERA
mode.
• While the automatic date/time adjustment is activated, the
> [
B
System Setup] > [Date/
Time] setting will not be available.
• The time will not be updated while recording video.
[Button Illumination]
[On]
, [Off] (
A
135)
[DC IN Warning (V)] 11.5 V to 15.0 V in 0.1 V intervals
(12.0 V)
(
A
27)
[Exp. Unit Batt. Warning (%)]
4
1% to 10%
(5%)
[Exp. Unit Batt. Warning (V)]
4
12.0 V to 15.0 V in 0.1 V intervals
(13.0 V)
[Power Saving Mode] [On],
[Off]
When this setting is set to [On], the camera’s power consumption is reduced.
The following functions cannot be used when this setting is set to [On]:
•
> [
¢
Monitoring Setup] > [LCD LM-V1 Luminance], [LCD LM-V2 Luminance] or [EVF-V70
Luminance].
• > [ Network Settings] > [Network].
• > [
¢
Monitoring Setup] > [LUT Selection: VIDEO Terminal] > [HDR Assist. (400%)] or [HDR
Assist. (1600%)].
[Retract Lens]
[On]
, [Off]
When one of the following lenses is attached to the camera and the focus mode switch on the lens is set
to AF, if this setting is set to [On], the lens will retract fully when the camera is turned off. This setting is
available only in CAMERA mode.
• EF 40mm f/2.8 STM
• EF-S 24mm f/2.8 STM • EF 50mm f/1.8 STM
[Reset Hour Meter] –
The camera has two “hour meters” – the first keeps track of total operation time and the second keeps
track of operation time since the last time the second hour meter was reset with this function. This setting
is available only in CAMERA mode.
[Firmware]
Menu item Setting options and additional information