Buffalo TeraStation TS3200D, User Manual

Page: 162 / 214

161
Sleep Mode
To save energy, you can specify times to put the TeraStation into sleep (standby) mode, during which the hard drive
and LEDs are turned off.
1
In Settings, click
Management
.
2
Click to the right of "Sleep Timer".
3
Click Edit .
4
Specify the timer interval, wake-up time, and time to go into sleep mode, then click OK .
Notes:
• Up to three timers can be set.
• The time to enter sleep mode can be set from 0:00 am to 3:45 of the next day.
The time to wake from sleep mode can be set from 0:00 to 23:45.
If the time to enter sleep mode is after 24:00, the wake-up time setting may be from 4:00 to 23:45.
• The time to enter sleep mode should not be set at the same time as or before the start time.
• If a backup job is scheduled during a disk check, disk format, backup job or within 5 minutes of the current
time, the TeraStation will not change to standby mode when the configured time is reached.
• If scheduled times in the timer overlap, operation is performed using the widest time interval.
• Examples of multiple timer settings are shown below.
Example 1: