Buell 2004 XB9S, Service Manual

Page: 229 / 597

3-26 2004 Buell Lightning: Engine
HOME
CAUTION
See Figure 3-24. At this point it is necessary to support
main frame with overhead hoist in order to remove rear
isolator bolt. Failure to do this will result in main frame
dropping slightly.
34. See Figure 3-25. After rotating engine back up into
frame, continue to remove:
a. Rear isolator bolt.
b. Swingarm pivot shaft.
35. See Figure 3-26. Support swingarm/oil tank with wooden
blocks, jack, etc.
36. See Figure 3-27. Cut the cable strap holding transmis-
sion vent line and pull vent line out of frame leaving it
attached to engine.
NOTE
The transmission vent line runs up the left side of the frame
and exits underneath the left rear side of the intake cover
assembly.
37. Lower engine with scissors lift all the way down.
38. Move the engine assembly from under the main frame to
the right side of the lift.
39. Remove engine.
Figure 3-24. Supporting Vehicle for Disassembly (Typical)
Figure 3-25. Rear Isolator Bolt and Swingarm Pivot Shaft
8716
8721
8722
Figure 3-26. Supporting the Swingarm
Figure 3-27. Transmission Vent Line
8719
8918