Buell 2004 XB9S, Service Manual

Page: 61 / 597

1-12 2004 Buell Lightning: Maintenance
HOME
CHANGING ENGINE OIL
AND FILTER
Ride motorcycle for approximately 10 minutes to ensure the
oil is hot and the engine is at normal operating temperature.
Turn engine off.
NOTE
Secure rear wheel on lift or place scissor jack under jacking
point.
Draining Oil
1. See Figure 1-4. Place a suitable container under the
drain plug.
2. Using a 5/8 in. wrench, remove drain plug from under oil
tank/swingarm. Wipe any accumulated debris from mag-
netic tip on drain plug.
3. See Figure 1-5. Unscrew and remove dipstick from oil fill
hole on top of oil tank/swingarm.
Changing Filter
1. Remove chin fairing See 2.34 CHIN FAIRING .
2. See Figure 1-6. Remove oil filter using pliers or belt type
OIL FILTER WRENCH.
3. Clean filter gasket contact surface on crankcase. Surface
should be smooth and free of any debris or old gasket
material.
4. Apply a thin film of clean engine oil to filter gasket.
5. Pour 4.0 ounces (0.12 liter) of clean engine oil into new fil-
ter when changing oil (until filter is approximately 1/2 full).
6. Screw filter onto adapter until filter gasket touches crank-
case surface. Rotate filter another 1/2-3/4 turn by hand.
1
WARNING
1
WARNING
Be sure no oil gets on tires when changing oil and filter.
Traction will be adversely affected which may lead to loss
of control which could result in death or serious injury.
Figure 1-4. Oil Tank Drain Plug
Figure 1-5. Dipstick Location
8375
8352
Figure 1-6. Oil Filter
8418