Brooks Automation
278580 Revision A
145
LF80C ZeniD RFID Reader
8 Service and Troubleshooting
Product Manual
8.4 Error Codes
* because the device is still busy or because a message has not been
confirmed by the previous read up to now
8.4.2
SSACK
C (12)
bad type
incorrect transponder
type
incorrect transponder
type is used (read
only or read/write
instead of Multipage)
check transponder type and
replace it
ID
Name
Description
Possible cause
Correcting action
SSAC
K
Name
Description
Possible cause
Correcting action
EE
Execute
error
transponder data and
read ID sequence can-
not be read
transponder has no or
too less valid ASCII
characters on MID
area
program transponder with valid
ASCII characters on MID area
parameters for MID
area are not match-
ing transponder data
set reader parameters for MID
area corresponding to tran-
sponder data area for the MID
reader is still busy
with a former read or
write request
wait until the former request is
done
incorrect reader mode
for operation
switch to correct mode (MANT
for writing MID)
CE
Communi-
cation
error
syntax error of mes-
sage ore message for-
mat or incorrect value
data sent with a com-
mand are wrong
check syntax and data of com-
mand
list format, amount of
lists or data type is
wrong
check syntax of SECS message
sent parameter is not
implemented or not
within the range
check syntax and parameter
value
TE
Tag error
no transponder or
antenna installed
no readable tag within
the reading range
put a transponder into the
antenna range, verify type and
function of the transponder
antenna is not
connected correctly
check antenna connection
antenna and
transponder are in a
bad orientation
check orientation between
antenna and transponder (see
Î
Antenna Installation)
antenna is not tuned
perform an antenna tuning
