216
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 14: DIAGNOSTICS
PARAMETER DESCRIPTION
IP Address: The destination IP Address.
Wait Time: Set the time (in seconds) to wait for a response to a probe (default 5.0 sec). Values range from 1 to 60. The payload size
of the ICMP packet. Values range from 2 bytes to 1452 bytes.
Max TTL: Specifies the maximum number of hops (max time-to-live value) traceroute will probe. Values range from 1 to 255. The
default is 30.
Probe Count: Sets the number of probe packets per hop. Values range from 1 to 10. The default is 3.
Buttons
Start: Click the “Start” button to start to traceroute the target IP Address.
New Ping: Back to Traceroute page.
14.3 CABLE DIAGNOSTICS
This section shows how to run Cable Diagnostics for copper ports.
WEB INTERFACE
To configure a Cable Diagnostics Configuration in the web interface:
1. Click Diagnostics and Cable Diagnostics.
2. Specify the Port to check.
3. Click Start.
FIGURE 14-3. CABLE DIAGNOSTICS
PARAMETER DESCRIPTION
Port: The port where you are requesting Cable Diagnostics.
Copper Port: Copper port number.
Link Status: The status of the cable.
10M: Cable is link up and correct. Speed is 10 Mbps.
100M: Cable is link up and correct. Speed is 100 Mbps.
1G: Cable is link up and correct. Speed is 1 Gbps.
