17
ENGLISH
www.bergcycles.com
Make sure the front and rear brake function
perfectly. Make sure that the brake control
cables are lubricated and have no obvious
wear.
Make sure your tires are inflated to
recommended pressure as indicated at the
side of the tire and do not shows excessive
wear.
Make sure that the rims of the wheel
running normally and that pose no obvious
twist. Make sure they have the correct
tension and in the closed position.
Make sure you are properly fitted and
adjusted.
Make sure the pedals are securelly at-
tached to the brackets. Make sure that the
cranksets are tight to the bracket motion.
Verify that the front and rear gears work
properly.
Verify that the frame and fork are not bent
or broken.
HANDLEBAR HEIGHT
Maximum comfort is normally achieved when the han-
dlebar height is levelled with the saddle height. You can
experiment different heights until you find the most
comfortable position.
NOTE:
The Aheadset steering does not let you to adjust
the height in the stem.
The stem’s “Minimum Insertion” mark must not be visi-
ble above the top of the headset. If the stem is extend-
ed beyond this mark, the stem may break or damage
the fork’s steer tube, which could cause you to lose
control and fall.
Failure to properly tighten the stem binder bolt, the
handlebar binder bolt, or the bar end extension clamp-
ing bolts may compromise steering action, which could cause you to lose control and fall. Place the
front wheel of the bicycle between your legs and attempt to twist the handlebar/stem assembly using a
reasonable amount of force. If you can twist the stem in relation to the front wheel, turn the handlebars
in relation to the stem, or turn the bar end extensions in relation to the handlebar, you must tighten the
appropriate bolts accordingly.
For more information see page 41.
MAINTENANCE AND SAFETY CHECKS PLAN
Local distributor offers the first full revision to the bike. This review should be done after the first five hours
of use and up to a limit of two months after the date of purchase. The review may not be done on time.
The maintenance and safety checks plan should be carried out according to the following schedule:
SCHEDULE 1:
BEFORE USING THE BICYCLE
FREQUENCY
COMPONENT
VERIFICATION
PROCEDURE
Before
using the
bicycle
Brake
Tires/ Inner tubes
Wheels
Steering
Brackets and pedals
Gears
Frame and Fork
Braking and broken
Cables
Pressure
Rim and spokes
Wheel clamping
Handlebar and stem
Pedals and brackets
Gears and broken wires
Cracks or creases
STEM TIGHTENING SCREW
MAXIMUM HEIGHT
MINIMUM INSERTION MARK
HANDLEBAR FIXING BOLT
2 ½ (64mm)
SURPLUS