Belden Grass Valley KALEIDO-X16, Installation & Service Manual

Page: 44 / 152

44
Frame Operation and IP Network Setup
Networking Essentials
The LEDs on the front of the frame (behind the cover) indicate the following conditions
depending on their color and whether they are blinking or not:
Networking Essentials
The following network prerequisites must be met:
• Any multiviewer you wish to configure or access by using XEdit or XAdmin must be
connected to an Ethernet switch.
• A client workstation must be connected to the LAN or Ethernet switch to access the
multiviewer by using XAdmin or XEdit.
• The Ethernet switch must support 100 Mbps full-duplex connections.
• The port on the Ethernet switch to which the multiviewer is connected should be
configured to auto-negotiate. By default, multiviewers have their Ethernet ports set to
auto-negotiate. If a switch does not support auto-negotiation, the recommended
settings are 100 Mbps, full-duplex.
LED
LED Status
Green
Blinking
green
Red Blinking red Yellow
Blinking
yellow
Off
CPU Normal
operation Application
booting Error Live Update OS Booting N/A Front cover
is closed
CPF Activity N/A Activity N/A N/A N/A N/A No Activity
Video Inputs Inputs are
locked
N/A Inputs are
unlocked, or
no input ERROR ON
SIGNAL N/A N/A Front cover
is closed
DVI Inputs Inputs are
locked N/A Inputs are
unlocked, or
no input ERROR ON
SIGNAL N/A N/A Front cover
is closed
LTC LTC valid N/A No signal N/A N/A N/A Front cover
is closed
Ref. Input Input is
locked N/A Input is
unlocked, or
no input ERROR ON
SIGNAL N/A N/A Front cover
is closed
SDTI Inputs are
locked N/A Inputs are
unlocked, or
no input, or
no SDTI
signal ERROR ON
SIGNAL N/A N/A Front cover
is closed
Gen. Status System OK Intrusive
self-
diagnostic
finished Configuratio
n Failed,
Safe Mode Firmware
Upgrading Boot up
Diagnostic
(Verbose
switch on) Firmware
error Front cover
is closed
Severity Boot OK Booting Boot error,
Need live-
update Fatal error,
CALL TECH
SUPPORT N/A N/A No power