Belden Grass Valley KALEIDO-X16, Installation & Service Manual

Page: 38 / 152

38
Multiviewer Cabling
Powering up the Kaleido-X16
To power up the Kaleido-X16
1 Plug the power cord(s) from the Kaleido-X16 into a grounded power outlet.
2 Press the power button at the front of the frame (behind the front cover).
The startup sequence takes a couple of minutes, during which time some video may
appear on any connected display. The startup is completed when the CPU LED is solid
green. See
Card Interfaces and Troubleshooting , on page 43 for more information.
IMPORTANT
• A Kaleido-X16 multiviewer can draw 4.0 amps of current. Ensure that the
circuit to which the frame is connected can handle that load, and that of
any other connected devices.
• If you only have one PSU, make sure you plug your power cable into the
power connector on the right side of the rear connector panel (as you face
the rear of the frame). This should be on the same side of the frame as the
one PSU you have installed. If you do not do this, your system cannot draw
power.
• If you have two PSUs, make sure you plug in both power cables into both
power connectors of the rear connector panel. If you do not do this your
system cannot have PSU redundancy.
IMPORTANT
• If you only have one PSU, make sure you plug your power cable into the
power connector on the right side of the rear connector panel (as you face
the rear of the frame). This should be on the same side of the frame as the
one PSU you have installed. If you do not do this, your multiviewer will not
power up.
• If you have two PSUs, make sure you plug in both power cables into both
power connectors of the rear connector panel. If you do not do this your
system will not have PSU redundancy.
Power socket for PSU B Power socket for PSU A
Power Button