Technical data • Complete system
32
Automation PC 3100 user's manual V0.60
2.5.3 Ethernet 1 interface (ETH1)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 1 interface (ETH1
1)
)
Controller
Intel I219
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Green
100 Mbit/s
10 Mbit/s
3)
Yellow
1000 Mbit/s
-
LED "Link"
On
Off
Yellow
Link (indicates connection
to an Ethernet network)
Activity (blinks to indi-
cate active data transfer)
RJ45, female
1
Table 18: Ethernet interface (ETH1)
1)
The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection only exists if LED "Link" is also lit at the same time.
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Only download necessary drivers from the B&R website, not from vendor websites.
2.5.4 Ethernet 2 interface (ETH2)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 2 interface (ETH2
1)
)
Controller
Intel I210
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Green
100 Mbit/s
10 Mbit/s
3)
Yellow
1000 Mbit/s
-
LED "Link"
On
Off
Yellow
Link (indicates connection
to an Ethernet network)
Activity (blinks to indi-
cate active data transfer)
RJ45, female
1
Table 19: Ethernet interface (ETH2)
1)
The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection only exists if LED "Link" is also lit at the same time.
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Only download necessary drivers from the B&R website, not from vendor websites.
