B&R Industrial Automation GmbH MAAPC3100-ENG, User Manual

Page: 10 / 177

General information • Overview
10 Automation PC 3100 user's manual V0.60
2.6.3 Viruses and dangerous programs
This system is subject to potential risk each time data is exchanged or software is installed from a data storage
device (e.g. diskette, CD-ROM, USB flash drive, etc.), network connection or the Internet. The user is responsible
for assessing these risks, implementing preventive measures such as virus protection programs, firewalls, etc. and
making sure that software is obtained only from trusted sources.
2.7 Environmentally friendly disposal
All programmable controllers, operating/monitoring devices and uninterruptible power supplies from B&R are de-
signed to minimize harm to the environment as far as possible.
2.7.1 Separation of materials
It is necessary to separate out the different materials so that devices can undergo an environmentally friendly
recycling process.
Component Disposal
Programmable logic controllers
Operating/Monitoring devices
Uninterruptible power supply
Batteries and rechargeable batteries
Cables
Electronics recycling
Cardboard/Paper packaging Paper/Cardboard recycling
Plastic packaging material Plastic recycling
Table 1: Environmentally friendly disposal
Disposal must take place in accordance with applicable legal regulations.
3 Organization of safety notices
Safety notices in this user's manual / data sheet are organized as follows:
Safety notice Description
Danger! Failure to observe these safety guidelines and notices can result in death, severe injury or substantial damage to property.
Caution! Failure to observe these safety guidelines and notices can result in severe injury or substantial damage to property.
Warning! Failure to observe these safety guidelines and notices can result in injury or damage to property.
Information: These instructions are important for avoiding malfunctions.
Table 2: Organization of safety notices
4 Guidelines
E
European dimension standards apply to all dimension diagrams.
All dimensions are specified in mm.
Unless otherwise specified, the following general tolerances apply:
Range of nominal size General tolerance per
DIN ISO 2768 (medium)
Up to 6 mm ±0.1 mm
6 to 30 mm ±0.2 mm
30 to 120 mm ±0.3 mm
120 to 400 mm ±0.5 mm
400 to 1000 mm ±0.8 mm
Table 3: Range of nominal sizes
5 Overview
Model number Short description Page
Accessories
0TB103.9 Connector 24 VDC - 3-pin female - Screw clamp terminal block 3.31 mm² 132
0TB103.91 Connector 24 VDC - 3-pin female - Cage clamp terminal block 3.31 mm² 132
5SWUTI.0001-000 HMI Service Center USB flash drive - Hardware diagnostic software - For APC810/PPC800 - For APC910/
PPC900 - For APC2100/PPC2100 - For APC51x/PP500 - For Automation Panel 800/900
123
Batteries
0AC201.91 Lithium batteries 4 pcs., 3 V / 950 mAh button cell 135