Commissioning • Installation
Chapter 3
Commissioning
Automation PC 3100 user's manual V0.60
101
Chapter 3 • Commissioning
1 Installation
Danger!
•
All power supplies must be disconnected before removing device covers or components and
installing/removing accessories, hardware or cables.
•
The power cable must be disconnected from the device and from the power supply.
•
All covers, components, accessories, hardware and cables must be installed or connected be-
fore the device can be connected to the power supply and switched on.
1.1 Important information concerning installation/commissioning
•
Checking the delivery
°
When receiving the delivery, check the packaging for any visible transport damage.
°
Any visible transport damage must be documented and reported immediately, or the damage must
be confirmed by the shipping/delivery company.
°
Keep the original packaging in the event that goods must be reshipped.
Information:
If a device is transported or stored without packaging, it is unprotected against all envi-
ronmental factors such as impacts, vibration, pressure, moisture, etc. Damaged pack-
aging indicates that environmental conditions have already heavily affected and possi-
bly damaged the device.
This can result in malfunctions on the device, machine or manufacturing system.
°
Check the packaging contents and any ordered optional accessories for completeness and dam-
age.
°
If the packaging contents are incomplete, damaged or do not match your order, inform your local
sales office or B&R headquarters immediately.
Danger!
A damaged device is subject to unpredictable properties and states. The unintentional
installation or operation of a damaged device must be prevented. The damaged device
must be marked as such and removed from the productive environment or sent imme-
diately for repairs.
•
The environmental conditions must be observed,
see "Environmental characteristics"
Caution!
Before the device is put into service, it must slowly be acclimated to room temperature! Sub-
jecting it to thermal radiation is not permitted. If transported at low temperatures or if there
are large temperature fluctuations, the device is not permitted to be subjected to any type of
moisture. Moisture can cause short circuits in the electrical circuits and damages the device.
•
You must observe the permissible mounting orientations when installing the device,
.
