AudioCodes Mediant 2000, User Manual

Page: 306 / 418

SIP User's Manual 306 Document #: LTRT-68808
Mediant 2000
Parameter Description
TrunkAdministrativeState
Defines the administrative state of a trunk.
ƒ
[0]
= Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
ƒ
[2]
= Unlock the trunk (default); enables trunk traffic.
ISDN Flexible Behavior Parameters
ISDN protocol is implemented in different Switches / PBXs by different vendors. Several
implementations vary a little from the specification. Therefore, to provide a flexible interface that
supports these ISDN variants, the ISDN behavior parameters are used.
ISDNInCallsBehavior
For a description of this parameter, refer to “Configuring the Trunk
Settings” on page
82 .
ISDNIBehavior
For a description of this parameter, refer to “Configuring the Trunk
Settings” on page
82 .
ISDNGeneralCCBehavior
For a description of this parameter, refer to “Configuring the Trunk
Settings” on page
82 .
ISDNOutCallsBehavior
For a description of this parameter, refer to “Configuring the Trunk
Settings” on page
82 .
ISDNIBehavior_x
Same as the description for parameter ISDNIBehavior, but for a
specific trunk ID.
ISDNInCallsBehavior_x
Same as the description for parameter ISDNInCallsBehavior, for a
specific trunk ID.
ISDNOutCallsBehavior_x
Same as the description for parameter ISDNOutCallsBehavior, but for
a specific trunk ID.
PlayRBTone2Tel
For a description of this parameter, refer to ''SIP General Parameters''
on page
121 .
PlayRBTone2IP
For a description of this parameter, refer to ''SIP General Parameters''
on page
121 .
ProgressIndicator2IP
For a description of this parameter, refer to ''Advanced Parameters''
on page
151 .
TimeForReorderTone
Busy or Reorder Tone duration that the device, when configured to
protocol type CAS, plays before releasing the line.
The valid range is 0 to 15. The default value is 10 seconds.
Applicable also to ISDN if PlayBusyTone2ISDN = 2. Selection of Busy
or Reorder tone is done according to release cause received from IP.
ISDNDisconnectOnBusyT
one
For a description of this parameter, refer to “Configuring the Digital
Gateway Parameters” on page
207 .
DisconnectOnBusyTone
For a description of this parameter, refer to Configuring the Digital
Gateway Parameters on page
207 .
EnableVoiceDetection
ƒ
[1]
= The device sends 200 OK (to INVITE) messages when
speech/fax/modem is detected from the Tel side.
ƒ
[0]
= The device sends 200 OK messages immediately after the
device finishes dialing to the Tel side (default).
Usually this feature is used only when early media (EnableEarlyMedia)
is used to establish voice path before the call is answered.
Notes:
ƒ
To activate this feature, set EnableDSPIPMDetectors to 1.
ƒ
This feature is applicable only when the protocol type is CAS.