AudioCodes Mediant 2000, User Manual

Page: 223 / 418

Version 5.6 223 November 2008
SIP User's Manual 3. Web-Based Management
3.5.1.1.1 Configuring the SNMP Trap Destinations Table
The 'SNMP Trap Destinations' page allows you to configure up to five SNMP trap
managers.
¾
To configure the SNMP Trap Destinations table, take these 5 steps:
1.
Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' on page
220 .
2.
In the 'SNMP Trap Destinations' field, click the right-pointing arrow button; the
'SNMP Trap Destinations' page appears.
Figure 3-91: SNMP Trap Destinations Page
3.
Configure the SNMP trap managers parameters according to the table below.
4.
Click the
Submit
button to save your changes.
5.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 230 .
Note:
Only table row entries whose corresponding check boxes are selected are
applied when clicking
Submit
; otherwise, settings revert to their defaults.
Table 3-58: SNMP Trap Destinations Parameters Description
Parameter Description
SNMP Manager
[SNMPManagerIsUsed_x]
Determines the validity of the parameters (IP address and port
number) of the corresponding SNMP Manager used to receive SNMP
traps.
ƒ
[0]
(Check box cleared) = Disabled (default)
ƒ
[1]
(Check box selected) = Enabled
IP Address
[SNMPManagerTableIP_x]
IP address of the remote host used as an SNMP Manager. The device
sends SNMP traps to these IP addresses.
Enter the IP address in dotted-decimal notation, e.g., 108.10.1.255.
Trap Port
[SNMPManagerTrapPort_x
]
Defines the port number of the remote SNMP Manager. The device
sends SNMP traps to these ports.
The valid SNMP trap port range is 100 to 4000. The default port is
162.