AudioCodes Mediant 2000, User Manual

Page: 62 / 418

SIP User's Manual 62 Document #: LTRT-68808
Mediant 2000
3.4.1.5 Configuring the IP Routing Table
The 'IP Routing Table' page allows you to define up to 50 static IP routing rules for the
device. For example, you can define static routing rules for the OAMP and Control networks
since a default gateway is supported only for the Media traffic network (refer to ''Configuring
the Multiple Interface Table'' on page
53 ). Before sending an IP packet, the device
searches this table for an entry that matches the requested destination host / network. If
such an entry is found, the device sends the packet to the indicated router. If no explicit
entry is found, the packet is sent to the default gateway (configured in the 'IP Settings'
page-- refer to ''Configuring the IP Settings'' on page
50 ).
¾
To configure static IP routing, take these 3 steps:
1.
Open the 'IP Routing Table' page (
Configuration
tab >
Network Settings
menu >
IP
Routing Table
page item).
Figure 3-38: IP Routing Table Page
2.
In the 'Add a new table entry' group, add a new static routing rule according to the
parameters described in the table below.
3.
Click
Add New Entry
; the new routing rule is added to the IP routing table.
To delete a routing rule from the table, select the 'Delete Row' check box that corresponds
to the routing rule entry, and then click
Delete Selected Entries
.
Table 3-11: IP Routing Table Description
Parameter Description
Destination IP Address
[RoutingTableDestinationsColumn]
Specifies the IP address of the destination host /
network.
Destination Mask
[RoutingTableDestinationMasksColumn]
Specifies the subnet mask of the destination host /
network.