Arkray SPOTCHEM EZ SP-4430, Operating Manual

Page: 22 / 139

C SP-4430 ● 1-13
1-1
SP-4430
の概要
Chapter 1 INTRODUCTION
1-4-3
This section explains the way to load thermal printer paper, and set data
and time after turning on the power switch.
First operation after setting up
Turn on the power. 1.
Turn on the power switch on the rear
panel of the analyzer.
“|” is displayed.
After the analyzer name and system
version are displayed, warm-up
starts.
About 10 minutes after (room
temperature at 25
℃
), warm-up is
completed and the MAIN MENU is
displayed as shown at right.
●
●
●
For error correction or
troubleshooting, “see Chapter
5 Troubleshooting”.
▲
S P O T C H E M E Z
S Pー４４３０ V X X X X
W a r m i n g u p・・・ ／
１ . M e a s u r e ２ . S u b m e n u
３ . C a l i b r a t e
（ １／１ ）
Set the thermal printer paper. 2.
Set the attached thermal printer
paper (See 4-3-1 “Thermal printer
paper replacement”).
●
If the date is not set correctly, correct measurement results may not be
obtained and an error may occur.
Confirm the time and date. 3.
Set the date and time (see “3-6
Built-in Clock Adjustment”).
●
Remove the fixing tape on the protective cover. 4.
Press [1] on the MAIN MENU.
The Table Cover opens and the
Reagent Table and Centrifuge-
equipped Multi Rack slide forward.
●
IMPORTANT