78
WT315A
7. Remove the air filter housing.
8. Remove the ISC connector (A), MAP/IAT connector
(B), and TPS connector (C); then disconnect the throt-
tle cable (D).
WT397B
9. Loosen the clamp securing the throttle body to the
intake manifold; then remove the throttle body.
10. Connect the throttle cable to the throttle arm; then
install the throttle cable housing cover to the throttle
body. Secure with the screw.
11. Make sure the alignment tab on the throttle body
aligns with the slot in the intake boot and install the
throttle body fully into the boot. Secure with worm
clams and tighten securely.
WT567A
WT566A
12. Connect the ISC connector (A), MAP/IAT connector
(B), and the TPS connector (C).
WT397A
13. Install the air filter housing in place and install the
outlet boot of the housing over the throttle body.
Secure with the clamp.
14. With the existing cap screws, grommets, and spacers,
secure the lower portion of air filter housing to the
frame. Tighten to 5 ft-lb.
WT315A
15. Using new “patch lock” cap screws, secure the air fil-
ter housing mount to the intake manifold (A). Tighten
to 5 ft-lb; then secure the mount to the air filter hous-
ing (B). Tighten to 36 in.lb.
16. Install the engine intake tube and air intake to the air
filter housing and secure with the clamps.
