68
15. Install the starter idler gear and pin with the smaller
gear facing outward.
ROV1-065A
16. Install the starter gear on the crankshaft with the
shoulder facing outwards.
ROV1-105
17. If the flywheel and starter gear were removed, install
the starter gear onto the crankshaft; then install the
flywheel key.
KC543
NOTE: Be sure to wipe any grease or oil from the
end of the crankshaft.
18. Install the flywheel onto the crankshaft and secure
with the cap screw. Tighten to 60 ft-lb.
KC545
19. Using a gasket scraper, clean off the existing gasket
and case from the MAG cover. Using a new gasket
and dowel pins, install the cover making sure the cool-
ant pump shaft is aligned with the oil pump shaft.
Tighten to 7 ft-lb.
20. Install the chain guide and secure with the fastener.
ROV1-107
21. With two dowel pins and the gasket in place, install
the PTO-side cover onto the crankcase and tighten to 7
ft-lb.
ROV1-045A
Servicing Left-Side
Components
NOTE: The engine does not have to be removed
from the frame for this procedure.
