145
INSPECTING
1. Inspect the master cylinder push rod and clevis for
wear, bending, or elongation of clevis holes.
2. Inspect the push rod boot for tears or deterioration.
3. Inspect the reservoir for cracks and leakage.
4. Inspect the brake hose for cracks and deterioration and
the condition of the banjo-fittings.
INSTALLING
1. Place the master cylinder into position and secure with
cap screws. Tighten to 25 ft-lb.
WT513A
2. Install the pivot pin and secure with a new cotter pin;
then connect the switch.
3. Using four new crush washers installed on both sides
of the banjo fitting, secure the banjo bolts into the
master cylinder. Tighten to 20 ft-lb.
WT511A
4. Fill the master cylinder and bleed the brake system (see
Hydraulic Brake system in Periodic Maintenance/Tune-Up).
