10
WT041A
2. If low, remove the fill plug and add lubricant until it
appears at the level plug threads. Tighten the fill plug
to 16 ft-lb and the level plug to 45 in.-lb.
To check transaxle lubricant, use the following procedure.
1. Remove the fill/level plug; the lubricant level should
be level with the bottom of the plug threads.
WT025A
2. If low, add Arctic Cat Transaxle Fluid as necessary.
Tighten the fill/level plug to 16 ft-lb.
To change the lubricant, use the following procedure.
1. Place the vehicle on level ground.
2. Remove each drain and fill plug.
3. Drain the lubricant into a drain pan.
4. After all the lubricant has been drained, install the
drain plug and tighten to 16 ft-lb.
5. Pour the appropriate amount of recommended lubri-
cant into the fill hole.
6. Install the fill plug and tighten to 16 ft-lb.
NOTE: If the lubricant is contaminated with water,
inspect the drain plug, fill plug, and/or bladder.
Nuts/Bolts/Cap Screws
Tighten all nuts, bolts, and cap screws. Make sure rivets
holding components together are tight. Replace all loose
rivets. Care must be taken that all calibrated nuts, bolts,
and cap screws are tightened to specifications.
Headlight/Taillight-
Brakelight
HEADLIGHT BULB REPLACEMENT
1. Remove the wiring harness connector from the back
of the headlight.
2. Remove the rubber seal; then release the retaining
clip. Remove the bulb.
3. Install the new bulb; then attach the retaining clip and
press on the rubber boot.
4. Connect the wiring harness.
5. Adjust the headlight using the Checking/Adjusting
Headlight Aim instructions in this sub-section.
REMOVING HEADLIGHT ASSEMBLY
1. Remove the grille.
NOTE: Removing the front fender will aid in replac-
ing the headlight assembly.
2. Remove the headlight adjustment cap screw.
WT065A
3. Remove the inner cap screw securing the rear of the
headlight assembly.
WT272
4. Push the headlight assembly inward towards the radia-
tor and lift slightly on the exterior bracket until the
mounting stud is free; then remove the headlight
assembly.
5. Remove the rubber seal at the rear of the headlight
assembly.
