40
Removing Engine
Many service procedures can be performed without
removing the engine from the frame. Closely observe the
note introducing each sub-section for this important infor-
mation.
NOTE: To remove the engine, the taillight assembly,
left side panel, and left rear body panel must be
removed (see Steering/Frame/Controls).
NOTE: The vehicle must be supported on an appro-
priate stand for this procedure.
1. Remove the rear cargo box and rear fenders; then
remove the cap screws securing the rear splash panels
to the frame.
WT488A
WT489A
WT362A
2. Remove the left-rear wheel; then remove the outer
clutch cover. Retain the cap screws.
WT182A
3. Remove the cap screw securing the driven clutch to
the output shaft; then remove the stationary sheave of
the driven clutch along with the belt. Account for a
flat washer.
WT183A
4. Remove the cap screw securing the drive clutch.
Using an appropriate clutch puller, remove the drive
clutch. Remove the driven pulley moveable sheave.
WT186B
NOTE: When removing the stationary sheave,
account for the alignment shims (see Installing Left-
Side Components in the Engine section for proper
shimming).
