27
3. Install the tilt assembly onto the steering shaft and
secure it with new cap screws and lock nuts. Tighten
to 20 ft-lb.
WT351
4. Install the wave washer and washer; then install the
snap ring securing the shaft in place.
WT593
5. Install the rubber boot in place around the steering
shaft and secure with the existing push pins.
WT343
6. Install the dash; then install the steering wheel and
hood.
Steering Knuckles
REMOVING AND DISASSEMBLING
1. Secure the vehicle on a support stand to elevate the
wheel; then remove the wheel.
2. Remove the nut securing the hub.
3. Remove the brake caliper.
4. Remove the hub assembly.
5. Remove the cotter pin from the tie rod end and
remove the tie rod end from the knuckle.
6. Remove the upper cap screw securing the ball joint in
the knuckle.
7. Tap the ball joint end out of the knuckle; then slide the
axle out of the knuckle.
8. Remove the cap screw securing the lower ball joint to
the knuckle and remove the knuckle.
WT329A
9. Remove the snap ring securing the bearing in the
knuckle; then press the bearing out of the knuckle.
WT326
10. Using a suitable press, remove the bearing from the
knuckle.
WT327
CLEANING AND INSPECTING
1. Clean all knuckle components.
