30
WT099C
WT288A
INSTALLING
Align the mounting holes with the holes in the splash panel
and secure with the two torx-head screws and new lock nuts;
then tighten to 10 ft-lb. Snap the throttle cable bushing into
the actuator arm.
CHECKING CABLE FREE-PLAY
1. Check cable free-play by grasping the cable at the top
of the accelerator pedal and lightly pulling rearward to
remove slack. Free-play should be 1-2 mm (0.040-
0.080 in.).
WT099A
2. Depress the accelerator pedal completely and pull
rearward on the cable end. There should not be any
free-play and the tension sleeve should not be com-
pressed.
WT099B
3. To adjust the throttle cable, locate the in-line cable
adjuster beneath the clutch cover; then slide the pro-
tective sleeve upward from the adjuster.
WT081A
4. Loosen the jam nut (A) and turn the adjuster (B)
clockwise to increase free-play or counterclockwise to
decrease.
WT082A
5. Tighten the jam nut securely and slide the protective
sleeve over the adjuster making sure the sleeves over-
lap over the seal.
Shift Lever
REMOVING
1. Remove the seats, shifter knob, and center console.
