79
WT314A
17. Install the cargo box and rear body panels.
NOTE: If the throttle body, ECM, TPS, or ISC are
replaced, the EFI system must be synchronized. Use
the following procedure.
1. With the key off, depress accelerator pedal to Wide
Open Throttle (WOT).
2. Place the ignition key in the ON position and wait for
10 seconds.
3. Release the accelerator pedal, and wait an additional
10 seconds.
4. Turn the key to the OFF position and allow the gauge
to shut off.
Gas Tank
REMOVING
1. Remove the seats, engine access panel, and center console.
2. Remove the floor and side panels.
3. Remove the battery access panel and battery.
4. Remove the right rear side panel and right rear fender.
5. Remove the cap screws and discard the lock nuts
securing the right side frame tube.
WT365A
6. Remove the four cap screws securing the seat base to
the frame.
WT359A
7. Remove the remaining cap screws securing the frame
tubes to the frame. Remove both frame tubes.
WT360
8. Slide the gas tank slightly forward and disconnect the
gasline hose, vent hose, and fuel pump; then remove
the gas tank.
WT480A
INSTALLING
1. Place the gas tank into position; then connect the gasline
hose, vent hose, and fuel pump.
2. Place the two frame tubes into position and secure (but do
not tighten) with new “patch-lock” cap screws.
3. Install the remaining fasteners; then tighten all fasteners
securely.
4. Using new lock nuts, install the right side frame tube and
tighten securely.
! WARNING
Whenever any maintenance or inspection is made on the fuel
system during which there may be fuel leakage, there should
be no welding, smoking, open flames, etc., in the area.
