131
TA081
6. Using an appropriate bearing installer, install a new
bearing into the housing.
TA132
7. Install the large outer snap ring with the shim.
TA086
8. Install the gear into the housing.
TA077
9. Install the small inner snap ring with shim.
BACKLASH
1. Install the pinion shaft into the case. With the appro-
priate shim in place, secure with the snap ring.
TA073
NOTE: To determine the appropriate shim, start with
the thickest shim and install the snap ring. If the snap
ring will not fit in the groove, remove the shim and
install the next size smaller shim. Continue until the
snap ring can be installed.
2. With the appropriate shim in place and the O-ring
coated with molybdenum grease, install the pinion
gear assembly into the case half and secure with the
four screws. Tighten to 20 ft-lb.
TA025A
NOTE: To determine the appropriate shim, proceed to
step 3.
3. Using an appropriate tool, lock the pinion gear in place.
AT THIS POINT
If the pinion shaft or gear were replaced or serviced,
backlash must be checked. If not, proceed to ASSEM-
BLING HALVES.
