Upgrading Modero Firmware
132
VG-Series Modero Touch Panels
Upgrading the NXA-RGB and NXA-AVB/RGB Firmware
1.
Identify the Device number of the target panel being used for firmware routing to the accessories.
2.
Complete the instructions for configuring the NetLinx Master for IP communication found in the
Step 1: Prepare the Master for communication via an IP
section on page 125.
3.
Press the grey Front Setup Access button for
3 seconds
to open the Setup page.
4.
Press the
Video Adjustment
>
RGB Adjustment
buttons to open the RGB Adjustment page
(FIG. 102). This page displays the firmware for both the internal NXA-RGB card and the
communicating external NXA-AVB/RGB Breakout Box (BOB).
5.
Follow the procedures outlined within the
Step 2: Upgrade the NXA-BASE/B firmware via an
IP
section on page 130.
FIG. 102
RGB Adjustment page (showing the default values)
Incoming signal shown in the background
Firmware version of the NXA-RGB card
Firmware version of the NXA-AVB/RGB
If firmware is updated to either the panel or the breakout box, both units must be
power-cycled for the panel to detect and display the new BOB firmware version.
Summary of Contents for Modero NXT-1500VG
