AMX Modero NXT-1500VG, Operation/Reference Manual

Page: 27 / 252

Introduction
17 VG-Series Modero Touch Panels
VG-Series Modero Connectors
FIG. 1 shows the connectors on the VG-Series Modero panels.
Connecting and Using USB Input Devices
These panels can have up to two USB-capable input devices connected for use both on its different
firmware and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
1.
Insert the input device USB connectors into the appropriate USB connector on the panel.
2. Press the on-screen Reboot button (Protected Setup page) to save any changes and restart the panel.
3.
After the panel splash-screen disappears:
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its
location corresponds to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
1700VG Panel Specifications (Cont.)
Other AMX Equipment (Cont.): • Upgrade Compact Flash (factory programmed with firmware):
NXA-CFTPV256M - 256 MB V/VG compact flash card ( FG2116-43 )
NXA-CFTPV512M - 512 MB V/VG compact flash card ( FG2116-44 )
NXA-CFTPV1G - 1 GB V/VG compact flash card ( FG2116-45 )
FIG. 1 Connector layout on sample VG-Series Video Touch Panels (RGB connector available with RGB Kit)
RGB
AUDIO/VIDEO
RGB
ETHERNET
A L
12VDC
PWR
PROGRAM
Stereo
Audio-Video from
Ethernet
Power
NXT VG-Series
rear panel of the base
NXD VG-Series
on left side panel
NXA-AVB/RGB
(CAT5)
Keyboard/Mouse
USB connectors (2)
Mini-USB
(Program Port)
(CAT5)
Composite/RGB
and pass-thru
control (CAT5)
connectors located on connectors located
Output
USB-connected input devices are detected and recognized by the panel upon
connection. Refer to the
Configuring and Using USB with a Virtual
Master section on page 95 for more information on using a USB connection.